Ha this is awesome...I combed through this configuration but my brain never registered this! So, I adjusted the PCF as follows: #---------------------------------------------------------------------- # Default elbow types supported in AutoFitting. #---------------------------------------------------------------------- OPM_AUTOFITTING_ELBOW_TYPES = Short Radius;Long Radius; 3R #---------------------------------------------------------------------- # Default elbow angle types for trimmed elbows supported in AutoFitting. #---------------------------------------------------------------------- OPM_AUTOFITTING_TRIM_STOCK_ANGLES = 90;45;22.5;11.25 I'm able to now select 22.5 or 11.25 which is great for our custom specs which have these values. BUT, even though I set Short Radius as first in the variable, it still selects long radius by default. The pull-down menu now shows Short, then Long, then 3R, but Long is still the default selection. Could there be something else that drives that selection?
↧