I've used Instrument and Wiring for a few projects. So far, my experience is good using this software. I've also took 1 week course on Bentley I & W. Here what we learned during course : Design one loop ( like Flow Trans. and Flow Valve) and create for each instruments : Terminal Tstrip (Tstrip Table) Terminal Detail ( TERM table) Cable ( Cable Table ) Cable Wire Detail ( Core Table) After this, we save the loop as standard loop and use it as a template in creating future loops. In practice what we do is the following: use instrument list created with Bentley P & ID or import instrument list (excel file) for standard P & ID. We usually create specsheets after this. The problem is after this step. We already have a list of instruments ( with information and specsheets associate to them), but we cannot use standard loop template explain above because it apply only for new instruments, not for existing one. We end up to manually create Tstrip and Cable detail for each instruments ( time consuming). Is there a way to apply standard loop template to existing instrument (already created) ? Thanks, Eric
↧