Applies To Product(s): OpenPlant Isometrics Manager Version(s): 08.11.09.383 & above Environment: Windows 7 64 bit & Others Area: Processing Subarea: - Original Author: Rahul Kumar, Bentley Technical Support Group Overview Dimension Stub End: By default the lap joint stub end component dimension at its flange end part. See image below: To Dimension Lap Joint stub end from End point below is the customization which is required: Steps To Accomplish: In class editor, open OpenPlant_3D_Supplemental_Isometrics_Isoextractor.01.04 schema (%ProjectRoot%...Bentley\OpenPlantModeler V8i\WorkSpace\ Projects\OPModeler_Metric\ DataSet\Schemas\) Note: Above path location mentioned for default out of the box installation. Search Class “Lap Joint Flange”. Change the mapping for the lap joint end preps as follows: Change Calculated Port[0] > End Preparation from “IF” to “LJ” Change Calculated Port[1] > End Preparation from “IF” to “FL”. See image below for reference: 4. Save Schema and generate isometrics. It will dimension it from stub end. See images below: Comments or Corrections? Bentley's Technical Support Group requests that you please confine any comments you have on this Wiki entry to this Comments or Corrections?" section. THANK YOU!
↧