Applies To Product(s): AutoPLANT Modeler Version(s): 08.11.12.111 Environment: Windows 7 64 bit Area: General Subarea: Original Author: Dinesh Solanki, Bentley Technical Support Group Introduction Sometimes you may wonder why you are not getting AutoPLANT selection dialog on executing some commands like “View database”. This generally happens with specifics drawings only as the setting is applied to the drawings. Steps to Accomplish User “A” goes to AuoPLANT PipingàDatabase tools-->View database and no selection dialog comes up. See below. Due to this user cannot take advantage of Advance selection dialog. Solution Though a small setting in Drawing preferences it can be tricky if unaware about it. Enable “AutoPLANT Selection dialog” check button to get the required dialog. Result Comments or Corrections? Bentley's Technical Support Group requests that you please confine any comments you have on this Wiki entry to this Comments or Corrections?" section. THANK YOU!
↧
