One user is having a problem inserting Equipment Nozzles in a mixed metric model - see the attached image. On a horizontal tank he inserts a 1/2" 300LB flanged radial nozzle. The pipe part of the nozzle is drawn correctly at an outer diameter of 21.3 mm but the flange properties (OD and thickness) is multiplied by exactly 10... The spec has been checked and is ok. The problem is consistent for the user - all nozzles in this project behaves the same way. Other users don't see this problem, not even in the same file. AutoPLANT V8i SS3 Refresh Release (08.11.08.151) - 64 bit Any ideas, where I should look? Regards Henrik
↧
