Forum Post: Openplant Isomanager and posting Isosheet to PW

Howdy!
I have a couple of questionmarks with Isomanager.

Im a bit troubled how to setup a workflow for isometric drawings. Mainly because the "component" isosheet has one workflow and the dgn file isosheet has another workflow. How should we set this up? Shoudlnt these be linked together?
Would be nice if/when the dgn file isosheet changed state the "component" isosheet also changed state. Is this possible? At the moment we have to repost the isosheet from isomanager just to change state from lets say "In checking" to "Approved".
Any suggestions appreaciated.

On other thoughts about isomanager and isosheets....
Is it possible when posting a file from isomanager to projectwise also post for example "Attributes" to PW?
If no why is isomanager using textnodes and not tags like projectwise for the head of the drawing border? If it would have used tags it would have been possible to write "Attributes" to PW since theres a keyin for this.

Also ...how do I get the number of sheets to the isosheet?....this seems to have been removed when upgrading to OPM SS5.
I had a thought of using the projectwise document count and post all isosheets for one iso to the same folder in PW. The problem with this thought is that document count does also count versions. Maybe I could make a new property that only count latest version? But that seems like a bit tricky solution...are'nt there any better soultions out there?