Applies To Product(s): OpenPlant Isometrics Manager Version(s): 08.11.09.XXX Environment: Windows 7 (64 bit) Area: Settings/Attributes Subarea: Original Author: Rahul Kumar, Bentley Product Advantage Group In Isometric BOM, Pipe with different descriptions does not count separately. It produces a combined length/Quantity in Bill of Material. Requirement is to get a separate quantity in bill of Material whose description found to be different. This can be done by modifying the schema through class editor. It can be experienced using both OpenPlant modeler and AutoPlant Modeler. This has been shown in context with OpenPlant Modeler and OpenPlant Isometrics Manager. However similar approach could be utilized for AutoPLANT modeler and OpenPlant Isometrics Manager, by navigating to different project path. Background Different pipe description expected as B36.10 4 PE Pipe & B36.10 4 PE Pipe_For Coating on same pipeline. Steps to Accomplish In Class Editor, open ‘OpenPlant_3D_Supplemental_Isometrics_Isoextractor.01.04.ecschema’. For OpenPlant Modeler user, below is the path to check schema. ……..%....%\Bentley\OpenPlantModeler V8i\WorkSpace\Projects\User Project\DataSet\Schemas For AutoPLANT Modeler, below are the path to open schemas: ……..%....%\Bentley\Plant V8i\Bentley Plant V8i Projects\User Project\Config\OpenPlant\schemas Locate the 'Pipe' class to edit the schema. Go to class tab, under 'Isometric Component' custom attribute, add the value ‘this.DESCRIPTION’ in item code field as shown in image below. Save & close the schema. Launch Isometrics Manager and verify results. See image below for reference please. Lets Check another Case: User requirement is to split the Flanges with its unique Part ID. To incorporate it, similar customization, like explained above should be done to split the components with unique PARTID. See Steps below to get it. Steps to Accomplish In Class Editor, open ‘OpenPlant_3D_Supplemental_Isometrics_Isoextractor.01.04.ecschema’. For OpenPlant Modeler user, below is the path to check schema. ……..%....%\Bentley\OpenPlantModeler V8i\WorkSpace\Projects\User Project\DataSet\Schemas For AutoPLANT Modeler, below are the path to open schemas: ……..%....%\Bentley\Plant V8i\Bentley Plant V8i Projects\User Project\Config\OpenPlant\schemas Locate the 'WELD_NECK_FLANGE' class to edit the schema. Go to class tab, under 'Isometric Component' custom attribute, add the value ‘this.GUID’ in item code field as shown in image below. Note : For AutoPLANT Modeler user, COMP_ID property gets mapped with GUID. However user should check other property as well which stands unique to each Flange. Save & Close Schema. Launch Isometrics Manager and verify results. It should split the Component based on unique property value and create different PARTID. See Also Comments or Corrections? Bentley's Product Advantage Group requests that you please confine any comments you have on this Wiki entry to this Comments or Corrections?" section. THANK YOU!
↧