Applies To Product(s): OpenPlant Isometrics Manager Version(s): 08.11.09.xxx Environment: Windows 7 (64 bit) Area: Settings/Attributes Subarea: Original Author: Rahul Kumar, Bentley Technical Support Group In OpenPlant Isometrics Manager, the BOM report information may vary with respect to different requirements of the project, for example (FABRICATION, ERECTION, CONTINUOUS types). Background In OpenPlant Isometrics Manager, using OpenPlant Modeler/AutoPlant Modeler various BOM report types required as mentioned above. It can be achieved through modifying the report.def file under the style folder present under each project. Various types of reports can be created and stored under the style folder, which can be later utilized by renaming the files by the user. The information below will help the user to achieve various types of settings. This can be experienced by using both OpenPlant modeler and AutoPlant Modeler. This has been shown in context with OpenPlant Modeler and OpenPlant Isometrics Manager. However a similar approach could be utilized for AutoPLANT modeler and OpenPlant Isometrics Manager using the Isometric Configuration Dialog either using in session from within Project Administrator or from out of session using the Windows Start menu and launching the OpenPlant Isometrics Manager application. Steps to Accomplish For any FABRICATION report use these filters INCLUDE = IE_FIELD=0 EXCLUDE = IE_TYPE=CT_WELD Note: Disable any other available reports for example FLD by adding the hashtag (#) value as a prefix and keep the node number under Combi report (Optional). See image below: Save and Close report file and generate isometrics to verify results: For any ERECTION report use these filters INCLUDE = IE_FIELD=1 EXCLUDE = IE_TYPE=CT_WELD Note: Disable any other available report for example the SHP report by adding the hashtag (#) symbol as a prefix and keep the node number under Combi report (Optional). See image below: Save and Close report file and generate isometrics to verify results: For a CONTINUOUS report use this filter: EXCLUDE = IE_TYPE=CT_WELD In order to get a continuous numbering sequence, IE_PARTID_SF_COMBINED=1 should be set in style.cfg. See image below: Save and Close the report file and generate isometrics to verify results: To Generate Reports based on Size. Depending on different user case scenarios, some users want to extract various report types based on "Size" and wanted to generate BOM separately e.g. reports as Owner/Contractor BOM list. Please refer to the settings below in the report.def file. This will aid the user to achieve the desired configuration. The example referenced below has been considered to display to separate BOM, OWNER/CONTRACTOR, where OWNER BOM falls for size = 8 inches. Also to maintain the Item ID in both the BOM reports. Open Report.def file. Use format as outlined below:. Save and Close the report.def file and generate Isometrics to verify results. The user can also create a separate report for Fasteners and show it explicitly on the BOM report type along with different attribute types or based on certain requirements. See image below: Save and Close the report.def file and generate Isometrics to verify results. See Also Comments or Corrections? Bentley's Technical Support Group requests that you please confine any comments you have on this Wiki entry to this Comments or Corrections?" section. THANK YOU!
↧