Quantcast
Channel: OpenPlant | AutoPLANT
Viewing all articles
Browse latest Browse all 16985

Forum Post: RE: Has anyone received the following error message when placing a component (elbow from Spears catalog) in Openplant?

$
0
0
Thank you for your response back, I did not have any issues with a similar design at another facility using the spears catalor. I believe the problem is tied to a structural model that was referenced into my model. The file attached normally but after checking in the file with projectwise I was not able to open file in Openplant. The file did open in Microstation V8i, where I detached strucutural reference model that was created in AecoSims and Prostructure, both Bentley products. Even with file detached there seems to have left some markers in my openplant model. I had to place a fence around my model and clip void delete to clear up.

Viewing all articles
Browse latest Browse all 16985

Trending Articles



<script src="https://jsc.adskeeper.com/r/s/rssing.com.1596347.js" async> </script>