Hello Leonardo, Do you want to create an othogonal view with non orthogonal 3D model like the below ? As Dinesh mentioned, OPOM currtently doesn't support non-orthogonal view rotation. So just you can selet othogonal view rotate (0, 90 , 180, 270) in OPOM. Becuase, we can get cutting 3D volume with 3D min max box as a red box. If the original 3D model is non-orthogonal, OPOM will cut 3D volume as the below. If you want to cut non othogonal 3D volume as model rotation, OPOM should cut non othogonal 3D volume. But It would be almost impossible, it is very complicated to cut. if you want to create this view, you rotate the 3D model to orthogonal, and then create the output drawing. Dimenstion and tagging point would be correct but coordinate would be wrong such as Equipment location coordinate. you should modifty the coordinate. I'm sorry not to give the solution. If you have any qustion, Please let me know.
↧