Applies To Product(s): OpenPlant Modeler Version(s): 08.11.09.XXX Environment: Windows 7 64 bit Area: Component Subarea: Graphics Original Author: Kestutis Mitkus, Bentley Technical Support Group In OpenPlant Modeler, after Section clip placement and projection generation User is willing to have all centerlines visible. Background During Modeling in OpenPlant Modeler after Section clip placement, pipelines axes are shown only in the case where the sectional surface intersects the tube. Below are the steps of how to turn on Centerline visibility. Steps to Accomplish Open "View Attributes" dialog In this Dialog go to "OpenPlantModelerSettings" section. Click "Promote" button and check the Centerline checkbox See Also See Similar link for related problem on placement issue: http://communities.bentley.com/products/plant/design___engineering/w/plant_design_and_engineering__wiki/22659.how-to-show-centerline-on-hvac-ducts Comments or Corrections? Bentley's Technical Support Group requests that you please confine any comments you have on this Wiki entry to this "Comments or Corrections?" section. THANK YOU!
↧