Applies To Product(s): OpenPLANT Modeler Version(s): 08.11.09.462 Environment: Windows 7 64 bit Area: Component Subarea: Original Author: Dinesh Solanki, Bentley Technical Support Group Introduction You might experience while HVAC placement for rectangular and oval ducts that centerline for ducts are not shown. Centerline representation of ducts is not done by default so in case you need to show centerline for ducts please check the steps below: Steps to Follow Open configuration dialog from WorkSpaceàConfiguration Click New to enter new configuration variable HVAC_ADDCENTERLINE =1 and Save. See image below. 3. Now, begin placement of the ducts as shown below you will see the centerlines are placed. Comments or Corrections? Bentley's Technical Support Group requests that you please confine any comments you have on this Wiki entry to this "Comments or Corrections?" section. THANK YOU!
↧