Hi, I am trying to get isogen to number certain welds only when isometric is produced. I will have three types of welds. Fab Welds (shop welds), Site Welds (Field Welds) and Offshore Welds. I am using the Offshore weld to identify a unique weld type. I only want the Fiels Welds and Offshore welds to be numbered. Field Welds will be numbered FW1 etc and OffShore Welds will be CW1 etc. I have added these in my weld.wdf as below WELD-PREFIXES FABRICATION W ERECTION FW OFFSHORE CW SUPPORT-FABRICATION SF- SUPPORT-ERECTION SE- However in my isogen opl file there is no option to only number Site and Offshore welds I was thinking of then using Tack weld instead of Offshore weld but report from my weld file will show those as FW instead of CW. Any suggestions on how to get around this?
↧
