Applies To Product(s): OpenPlant Modeler Version(s): 08.11.09.XXX Environment: Windows 7 64 bit Area: Component Subarea: Graphics Original Author: Rahul Kumar, Bentley Technical Support Group In OpenPlant Modeler, to place a tap port on Blind flange. Background During Modeling in OpenPlant Modeler, placement of Tap port on Blind flange might be tricky and does not allow user to place it on face of flange. Below are the steps to aid modeler to be able to place the Tap port on Blind flange face. Steps to Accomplish Launch OpenPlant Modeler and select Project unit of working. Place Pipeline of main size DN25 in OpenPlant Modeler. Place a weld-neck flange and a Blind flange of same size. Switch view to illustration and orient the blind flange to face size. Select Size DN15 for Tap Port. Place it on Face of Blind flange. See image below. Toggle view to Wireframe Top view mode to check the placement of Tap port. See image below. See Also See Similar link for related problem on placement issue: Comments or Corrections? Bentley's Technical Support Group requests that you please confine any comments you have on this Wiki entry to this "Comments or Corrections?" section. THANK YOU!
↧
