Applies To Product(s): OpenPlant Isometrics Manager Version(s): 08.11.09.XXX Environment: Windows 7 64 bit & Others Area: Settings/Attributes Subarea: Original Author: Rahul Kumar, Bentley Technical Support Group Overview For OpenPlant Isometrics Manager Weld report can be generated using Report.def file present in Config folder located in its project root. It can be experienced using both OpenPlant modeler and AutoPlant. Problem Description While creating weld report through report.def file to show weld tags, they were not coming in numerical order. The weld order varied from line to line. See image below for reference. The weld tags need to be displayed in numerical order right from Top to Down. Below are the steps to achieve it in a correct way. Steps to Resolve Open report.def file from either by navigating the project root under Config folder or by launching the isometrics manager and using the Advanced option. Write the weld report as mentioned below. #----------------------------------------------------------------------------- REPORT = WELD EXCLUDE = IE_TYPE=CT_PIPE|CT_BEND|CT_BOLT|.*VALVE.*|CT_FLANGE|CT_ELBOW|CT_GASKET|CT_.*FITTING.*|CT_SUPPORT|CT_REDUCER|CT_OLET COLUMN = 6:C:WELDID COLUMN = 80:W:IE_DESCRIPT SORT = WELDID:N NODE = 61 END To get the weld tag in numerical folder, do not forget the mention the variable shown below. SORT = WELDID:N Save report.def file. Generate isometrics and verify results. See Also Configuring the BOM and Reports - http://communities.bentley.com/products/plant/design___engineering/w/plant_design_and_engineering__wiki/12642.configuring-the-bom-and-reports Comments or Corrections? Bentley's Technical Support Group requests that you please confine any comments you have on this Wiki entry to this Comments or Corrections?" section. THANK YOU!
↧
