Applies To Product(s): AutoPLANT Isogen Version(s): 08.11.XX.XXX Environment: Windows 7 64/32 bit Area: Configuration Subarea: Original Author: Abhijit Bute, Bentley Technical Support Group Error or Warning Message Explanation One of the project gives this error when generate isometric through Isogen. How to solve Refer following steps to resolve this issue. 1. Open the file C:\Program Files (x86)\Bentley\Plant V8i\Modules\Base\PCF.INI. 2. Add PWF = SW under the section [MAP_ENDCOND4SKEY] as shown below: [MAP_ENDCOND4SKEY] SCF = SC SCM = SC SWF = SW SWM = SW SOF = SW BW = BW BV = BW FL = FL FLL = FL PWF = SW 3. Save and close the file PCF.INI. 4. Run Isogen. Comments or Corrections? Bentley's Technical Support Group requests that you please confine any comments you have on this Wiki entry to this Comments or Corrections?" section. THANK YOU!
↧