Hi, Please follow the steps below to show Insulation material as "Fiber Glass" rather than FIBER_GLASS: 1. Launch Class Editor and load OpenPlant_3D schema supplemented with OpenPlant_3D_Supplemental_Modeling schema. 2. Go to PIPE class and select INSULATION property in properties tab. 3. Click Override button to enable the custom attributes for editing. 4. In the Extend Type custom attribute, change the Name field to LOOKUP_VALUE_MAP_USE_DISPLAY_LABEL. 5. Save the changes in schema. 6. Close OpenPlant Modeler and launch again. 7. Open the same model, right click on the component and select Modify component. 8. Re-set the Insulation Material for that component to Fiber Glass and save the changes. 9. Re-Generate the Iso-sheet and publish the I-model. 10. Load the I-model in OPIM and create an isometric drawing. 11. Check the Insulation material field in component tag. You can also refer to the below link: http://communities.bentley.com/products/plant/design___engineering/w/plant_design_and_engineering__wiki/17806.to-assign-filter-on-specific-property Hope this helps. Regards, Harpreet
↧