Hello Vivek, Thanks for your concern here. You could use Auto Branch Table for reinforcement branches. However you could add the Custom Attribute 'OpenPlant_Physical_catalogue_Class_Map' under OpenPlant_3D_supplemental_Modelling.01.04 schema.to get the value under catalog component section. Below are the steps to accomplish: 1. In Class Editor, open 'OpenPlant_3D.01.04.ecschema'. 2. Supplement it with OpenPlant_3D_Supplemental_Modeling.01.04.ecschema. 3. Navigate to desired class. 4. On easy method would be to copy the existing custom attribute from other class. Say Equal Pipe Tee. 5. Copy the Custom attribute as shown below. 6. Paste the custom attribute to desired class. See image below. 7. Save & Close schema 8. Launch Spec Gen and check entry of desired class under component list. Hope this helps! Regards, Rahul Kumar
↧