Applies To Product(s): OpenPlant Modeler Version(s): 08.11.09.404 Environment: Windows 7 64 bit Area: Properties Subarea: - Original Author: Rahul Kumar, Bentley Technical Support Group Overview For OpenPlant Modeler Filter option for any specific property required to display in dialog box information. This can be achieved by adding few Custom Attributes on its desired property. Problem Description In OpenPlant Modeler, some of the property needs to have filter option to select a value of that property which could be further used in OpenPlant isometrics manager to display the property value as Yes/No. Below solution illustrates the new property creation, say PWHT and assigning filter on its property. Steps to Resolve Launch the Bentley Class Editor. Open Schema ‘OpenPlant_CustomAttributes.08.11.ecschema’ from ….%ProjectRoot%\WorkSpace\OPModeler\schemas – It will enable to pick desired CA’s (Custom Attributes). Again Open OpenPlant_3D.01.04.ecschema.xml Schema from …%ProjectRoot%\WorkSpace\Projects\OPModeler_Metric\DataSet Supplement it with OpenPlant_3D_Supplemental_Modeling.01.04.ecschema.xml Schema (Optional). Under Value Map, Create one class. Say ‘DESIGN_CONDITION_MAP and create 2 property Yes/No in it. See image below. Save & close schema mentioned above. Open OpenPlant.01.04.ecschema.xml Schema from Path …%Project Root%\WorkSpace\OPModeler\schemas. Under PIPING_NETWORK_SYSTEM class, create a property say PWHT. And add CA’s as per below image. Note: Please Check the location for custom Attributes. Launch OpenPlant Modeler, and Place a pipe. Check Design Conditions tab, it will provide an option to pick Yes/NO. See image below. Publish I model and generate isometric to verify results. Comments or Corrections? Bentley's Technical Support Group requests that you please confine any comments you have on this Wiki entry to this Comments or Corrections?" section. THANK YOU!
↧