Applies To Product(s): OpenPlant Isometrics Manager Version(s): 08.11.09.404 & above Environment: Windows 7 64 bit & Others Area: Settings/Attributes Subarea: Original Author: Rahul Kumar, Bentley Technical Support Group For Bentley OpenPlant Isometrics Manager BOM report consist of PARTID numbers including other necessary description. Background In OpenPlant Isometrics Manager, using OpenPlant Modeler/AutoPlant Modeler various BOM report types also include PARTID, which allow each component/fittings to clearly distinguish one part from other parts when the difference is meaningful. Below are the steps signifies the sorting way for PartID. Steps to Resolve A . Reports Need for Down. 1. Open report.def file from either by navigating the project root under Config folder or by launching the isometrics manager and using the Advanced option. 2. Write the part ID as mentioned below. Also see report image shown below. GROUP = PARTID SORT = PARTID:N 3. Save report.def file. 4. Generate isometrics and verify results. See image below. B. Reports Need for Up 1. Open report.def file from either by navigating the project root under Config folder or by launching the isometrics manager and using the Advanced option. 2. Write the part ID as mentioned below. Also see report image shown below. GROUP = PARTID SORT = PARTID:ND 3. Also write the combi report as mentioned below. 4. Save report.def file. 5. Generate isometrics and verify results. See image below See Also Configuring the BOM and Reports - http://communities.bentley.com/products/plant/design___engineering/w/plant_design_and_engineering__wiki/12642.configuring-the-bom-and-reports Comments or Corrections? Bentley's Technical Support Group requests that you please confine any comments you have on this Wiki entry to this Comments or Corrections?" section. THANK YOU!
↧
