To add a leader line in OpenPlant Isometrics Manager. Background During Isometrics drawing generation process through both OpenPlant Modeler/AutoPlant Modeler, dimensions are placed on top of line, which has been set be default by OpenPlant Isometrics Manager. To facilitate Leader line for dimensions below steps are required. Steps to Accomplish Open the seed file From the MicroStation menu bar select: Element > Dimension Styles. Select the Geometry tab. Change the Dimension with Leader section to as shown below. Give a Save Settings command (CTRL+F). Verify result. In case there is not enough space to place the dimension value between the dimension end points, MicroStation will place the dimension value at a distance from the dimension line. Note- MicroStation “Modify Element” tool can modify every part of the dimension.Moving the text and dimension line are the most common uses. See below. Comments or Corrections? Bentley's Technical Support Group requests that you please confine any comments you have on this Wiki entry to this "Comments or Corrections?" section. THANK YOU!
↧