Hi Jeremy, Tell Scott I said hello as well. In regards to your AutoPLANT Specification use in OpenPlant: There are two ways to use AutoPLANT Specs in OpenPlant. Natively - after loading OpenPlant Modeler - from Specification selection drop down pick on Select Source. Then you can set the source to AutoPLANT. This will have a slight performance hit. After loading OpenPlant Specification Generator and before loading the AutoPLANT spec. From the Tools menu (I don't have it open right now so I believe Tools is correct.) pick on Upgrade to OPM. Then follow the prompts. This will upgrade the spec to OPM by adding the ECClass name to every record in the spec. NOTE - If you have a custom component in AutoPLANT this will not get an ECClass name unless one exist. This means you may need to add the custom component class to your OpenPlant schemas. I hope this helps, Tony DeRosa Bentley Plant
↧